DATA SHEET
ORDER NOW

EZF 2408 0.40

The EZF 2408 0.40 system is a two component polymeric MDI based polyurethane system, utilizing water as a sole blowing agent. The system is formulated primarily for packaging applications. It produces low density foam with good dimensional stability and low odor. The components can be easily processed through most types of polyurethane dispensing equipment. It is water blown and has good resilience and recovery. Small quantities can be hand mixed, or our E-Z Flow dispensing system can be used with very good results.

Ideal for shipping out the following:

Budget Conscious

Electronics Packaging

Medical Instrument Packaging

Ceramic Packaging

Shock & Vibration Absorption

Containers for both Side-A and Side-B components should be kept tightly closed to prevent moisture contamination. Do not reseal if contamination is suspected. To extend teh chemical's life, the use of a dry nitrogen blanket for partial drums is recommended. Both chemicals may be stored at ambient temperatures (50-95 degrees F). For best results, this product should not be allowed to freeze. Do not breathe aerosol or vapors and avoid contact with skin and eyes. Exposure to vapors of MDI (A-side chemical) heated in an open container can be dangerous.

Appropriate literature is available from the E-ZZ Flow which provides information concerning the health and safety precautions that must be observed when handling any of the products listed above. Before working with these products, it is your responsibility to read and become familiar with the available information on the hazards, proper use and handling. This is extremely important and connot be overemphasized. Information is available in several forms, e.g. safety data sheets and product labels. To obtain this information, contact your E-Z Flow Systems representative.

Physical Properties

Typical Values

Cream Time

6 seconds

Rise Time

30 seconds

Tack Free Time

34 seconds

Density, core, D1622

0.43 - 0.46 pcf

Shelf life

6 months

Physical Properties

Typical Values

Machine

E-Z Flow Gen IV
Foam-in-Place System

Air Pressure Range
for 2:1 Pumps operation

95-110PSI

Isocyanate (A) side Initial Temperature Setting

100 F

Polyol Resin (B) side
Initial Temperature Setting

120 F

The B-Side temperature should always be 10-15 degreees warmer than the A-side. Different temperatures may be required for best results. Consult your E-Z Flow Representative for optimization. Temperature above 140 F should be avoided on A-side.

Connect With Us

Need support or more information?
Head over to our contact page. Our team is ready to assist.

Contact Us