DATA SHEET
ORDER NOW

EZF 2.0 Fast Set

EZF 2.0 Fast Set polyurethane, fire retardant, rigid foam systems are designed to meet a variety of requirements without sacrificing product quality. The unique handling characteristics of the EZF 2.0 systems provide ease of mixing either by hand or with E-Z Flow dispensing equipment produce a uniform product with excellent cell structure. This product does not contain any CFC blowing agents.

Ideal for shipping out the following:

Marine Flotation

Fire Retardant

Void Fill

Structural

Insulation

Containers for both Side-A and Side-B components should be kept tightly closed to prevent moisture contamination. Do not reseal if contamination is suspected. To extend teh chemical's life, the use of a dry nitrogen blanket for partial drums is recommended. Both chemicals may be stored at ambient temperatures (50-95 degrees F). For best results, this product should not be allowed to freeze. Do not breathe aerosol or vapors and avoid contact with skin and eyes. Exposure to vapors of MDI (A-side chemical) heated in an open container can be dangerous.

Appropriate literature is available from the E-ZZ Flow which provides information concerning the health and safety precautions that must be observed when handling any of the products listed above. Before working with these products, it is your responsibility to read and become familiar with the available information on the hazards, proper use and handling. This is extremely important and connot be overemphasized. Information is available in several forms, e.g. safety data sheets and product labels. To obtain this information, contact your E-Z Flow Systems representative.

Physical Properties

Typical Values

Cream Time

28 - 35 seconds

Rise Time

120 - 180 seconds

Demold Time

5 - 20 minutes

Density, pdf

2.2 lbs/ft3 (35.2 kgs/m3)

Compressive Strength, Parallel

31 psi (0.214 MPa)

Compressive Strength, Perpendicular

25 psi (0.172 MPa)

Shear Strength

35 psi (0.241 MPa)

Closed Cell Content

88%

Physical Properties

Typical Values

Machine

E-Z Flow Gen IV
Foam-in-Place System

Air Pressure Range
for 2:1 Pumps operation

95-110PSI

Isocyanate (A) side Initial Temperature Setting

105 F

Polyol Resin (B) side
Inital Temperature Setting

115 F

Different temperatures may be required for best results. Consult. your E-Z Flow Representative for optimization. Temperatures above 140 F should be avoided on A-side.

Connect With Us

For more information, please visit our contact page.
Our team is available to assist you.

Contact Us