DATA SHEET
ORDER NOW

EZFloat 2.0


EZFLOAT 2.0 polyurethane, fire retardant, rigid foam system is designed to meet a variety of requirements without sacrificing product quality. The EZFLOAT 2.0 systems can be formulated in a wide range of densities from 1.8-6.0 pounds per cubic foot. The unique handling characteristics of the EZFLOAT 2.0 series system provides ease of mixing by hand or machine and produce a uniform product with excellent cell structure. This product does not contain any CFC or HFC blowing agents.

Ideal for shipping out the following:

Marine Flotation

Fire Retardant

Void Fill

Structural

Insulation


Containers for both A and B components should be kept tightly closed to prevent moisture contamination. Do not reseal if contamination is suspected. Use of a dry nitrogen blanket for partial drums is recommended. Side-B may be stored at ambient temperatures. Storage for Side-A should be maintained between 77°F (25°C) and 95°F (35°C). An additional note of caution is that exposure to temperatures over 200°F (102°C) can create excessive pressure potentially causing containers to rupture. Do not breathe aerosol or vapors and avoid contact with skin and eyes. Exposure to vapors of heated MDI can be dangerous. To heat product properly, use well ventilated convection ovens or other methods that distribute heat evenly. Avoid using drum heaters or other heat sources that may cause excessive local heating.


Appropriate literature is available from E-Z Flow which provides information concerning the health and safety precautions that must be observed when handling any of the products listed above. Before working with these products, it is your responsibility to read and become familiar with the available information on the hazards, proper use and handling. This is extremely important and cannot be overemphasized. Information is available in several forms, e.g. safety data sheets and product labels. To obtain this information, contact your E-Z Flow Foam Systems representative.

Physical Properties

Typical Values

Cream Time

35 - 40 seconds

Rise Time

200 - 250 seconds

Demold Time

5 - 20 minutes

Density, pdf

2.2 lbs/ft3 (35.2 kgs/m3)

Compressive Strength, Parallel

40 psi (0.275 MPa)

Compressive Strength, Perpendicular

28 psi (0.193 MPa)

Shear Strength

37 psi (0.255 MPa)

Closed Cell Content

>95%

Connect With Us

For more information, please visit our contact page.
Our team is available to assist you.

Contact Us