DATA SHEET
ORDER NOW

EZ Flex 1.0

The EZ Flex 1.0 series polyurethane packaging foam systems are designed for shock absorbing applications. This is a premium, flexible foam with a dense skin which gives the foam the ability to support heavy and expensive shipments such as file servers, test equipment, etc. It has more cushion and recovery than most packaging foam and can be used in bag machines effectively to make complex shapes. The unique handling characteristics of these systems provide ease of mixing through a variety of dispensing machines and will produce a uniform product with excellent cell structure. This product does not contain any CFC or HCF blowing agents. These systems can also be formulated with fire retardants upon request to meet customer requirements. These systems are noted with the letters FR following the product code.

Ideal for shipping out the following:

Electronics Packaging

Medical Instrument Packaging

Ceramic Packaging

Shock & Vibration Absorption

Void Fill

Pre-Mold Inserts

Containers for both Side-A and Side-B components should be kept tightly closed to prevent moisture contamination. Do not reseal if contamination is suspected. To extend teh chemical's life, the use of a dry nitrogen blanket for partial drums is recommended. Both chemicals may be stored at ambient temperatures (50-95 degrees F). For best results, this product should not be allowed to freeze. Do not breathe aerosol or vapors and avoid contact with skin and eyes. Exposure to vapors of MDI (A-side chemical) heated in an open container can be dangerous.

Appropriate literature is available from the E-ZZ Flow which provides information concerning the health and safety precautions that must be observed when handling any of the products listed above. Before working with these products, it is your responsibility to read and become familiar with the available information on the hazards, proper use and handling. This is extremely important and connot be overemphasized. Information is available in several forms, e.g. safety data sheets and product labels. To obtain this information, contact your E-Z Flow Systems representative.

Physical Properties

Typical Values

Cream Time

10 - 15 seconds

Rise Time

30 - 40 seconds

Demold Time

1 minutes

Density, pdf

0.45 - 0.55 lbs/ft3

Compressive Strength, Parallel

N/A psi (MPa)

Compressive Strength, Perpendicular

N/A psi (MPa)

Shear Strength

N/A psi (MPa)

Closed Cell Content

N/A %

Physical Properties

Typical Values

Machine

E-Z Flow Gen IV
Foam-in-Place System

Air Pressure Range
for 2:1 Pumps operation

95-110PSI

Isocyanate (A) side Initial Temperature Setting

120°F

Polyol Resin (B) side
Initial Temperature Setting

140°F

Different temperatures may be required for best results. Consult. your E-Z Flow Representative for optimization. Temperatures above 140°F should be avoided on A-side.

Connect With Us

For more information, please visit our contact page.
Our team is available to assist you.

Contact Us